Type: Driver
File Name:
File Size: 15.2 MB
5 (3.44)
Downloads: 4
Supported systems: Windows 10, 8.1, 8, 7, 2008, Vista, 2003, XP, Other
Price: Free* (*Free Registration Required)

Download Now

Packard Bell.

Hannspree, Nokia, Daewoo. Tatung, iZ3D, Inc, Matrox. Royal Information Electronics Co. Gran Prix. Mega Plus. Sichuan Changhong. General Nanosystems.

A monitor model chassis S

V Squared. Pixel Pro. AG Neovo.

New Vista. Digital Research Technologies. Value Line. Idek iiyama.

Sun Microsystems. PCMI Group. Tft Icd. Touch N Tune. EDP Classic. Action Printer.

Accu Scan. Value Point. Santa Clara System.

Satellite Pro. Wise Wing. If your Daytek AlphaScan 511S model is a Samsung CKA, the horizontal scan range is 30 to 55 KHz, and the vertical scan range is 50 to Hz; maximum resolution is by I need the value and part number of Q Occasionally flickers to green during use. Is green after wake up from sleep? Checked cabling, they are ok.

To access them properly, you generally first need to remove the Daytek AlphaScan 511S IC's with staggered leads, that are obscuring them. For your 'green' problem, I would first check the SMD resistor 2. Found dead Q, replaced with BU, failed after a few seconds. C is o.

DAYTEK DT-1536D Driver Download

The problem is that the HT rises to vv Daytek AlphaScan 511S dies back Daytek AlphaScan 511S. It then stays in a safety mode unless it is disconnected from the mains and reconnected again, it then repeats the above. Also if the LopTr HOT is disconnected and a dummy load is used or not usedthe results are the same. Is this a fusable link?

  • Mac Monitor Database
  • Daytek drivers free download software for all devices
  • DP Monitor Drivers Companies Computer Hardware
  • Sampo AlphaScan 511L CRT Monitor
  • Monitor Model Chassis
  • DVD readers
  • Defectos y Soluciones de Monitores

A fast-acting 1 Amp picofuse can substitute. To adjust this data, you must enter factory mode, and Daytek AlphaScan 511S service manual is advised, as the procedure runs several pages in the manual. Try getting a service manual from a place like Electronicsrepair.


After a few minutes of power on, the monitor will be out of focus. Daytek AlphaScan 511S the focus knob at the flyback regain the good focus condition, but after a few minutes it will be out of focus again. Drifting focus like this is usually caused by a defective focus block on the flyback. I need the value.

Alphascan 718 Driver

Download DAYTEK AlphaScan monitor drivers or install DriverPack Solution software for driver update. Download DAYTEK monitor drivers or install DriverPack Solution software for driver scan and Popular DAYTEK monitors. AlphaScan · AlphaScan S.

Other Drivers