Type: Driver
File Name:
File Size: 10.2 MB
9 (4.37)
Downloads: 11
Supported systems: Windows XP (32/64-bit), Windows Vista, Windows 7, Windows 8.1, Windows 10
Price: Free* (*Free Registration Required)

Download Now

If changes were made to any settings to the Encore Router before, make sure you "hardware reset" the Encore Router to the factory default Encore ENHWI-G. Check the User's Manual on how to "hardware reset" Encore ENHWI-G router.

Hooking up hardware connections: Disable the wireless client from your PC or laptop computer if not done so Connect the Ethernet cable to the PC or laptop computer and the Encore Router. This can be done while PC computer and router are turned on. Click the "OK" button to the warning box. Wait around 35 seconds until your screen comes back to Encore user interface screen, this time the screen is now in the Repeater Mode. As of this moment your repeater is not connected to any router or network. It has to be configured further to be able to be connected to your current Encore ENHWI-G and access point router.

Connecting your Repeater to your existing network access point or router: As soon as Encore ENHWI-G Encore Router switched to the Repeater Mode, you should be able to Encore ENHWI-G the same Utility Screen with fewer selections on the left pane. From the Main Menu screen click on "Wireless" located on the left pane.

Encore ENHWI-G Network Driver

Click on "Site Survey" button, a new Window dialogue box will pop up showing a list of Access Points reachable by your Repeater Check your existing network's access point SSID then click on the radio button that corresponds to your access point router then click "Connect" button. If Encore ENHWI-G can't find your existing AP router, click on "Refresh" repeatedly until your access point show up, or your location is too far from your existing AP router. Click on the "Encryption" drop down menu, select your existing access point wireless security, enter your existing router's wireless security key or passphrase then click "Apply". If you get a FAILED message, repeat this procedure again, a wireless hiccup might be interfering, otherwise you now have a working Repeater. Check your repeater connection by going to your internet browser and open a web page of your choice.

If successful your new wireless repeater is working. Disconnect the Ethernet cable Encore ENHWI-G setup your computer back to its original wireless settings. At this stage, the Repeater is now invisible to any wireless client computers.

Step 1 It is important to setup a static ip address in the device that you Encore ENHWI-G forwarding a port to. This ensures that your ports will remain open even after your device reboots.

Recommended - Our free program will setup a static IP address for you. After setting up Encore ENHWI-G static ip address on your devices you need to login to your router.

Encore ENHWI-2AN3 - wireless router - b/g/n (draft ) - desktop Overview - CNET

Your router has a web interface, so you will login to it using your web browser. It usually does not matter which browser you choose to use. Open up your web browser and find the address bar. It should look Encore ENHWI-G like this: Your router's IP address can also be refered to as your computer's default gateway. By default the IP address is set to: Encore ENHWI-G all goes well you will see the following screen:Find the default login, username, password, and ip address for your Encore ENHWI-G router.


You will need to know Encore ENHWI-G when you get a new router, or when. View and Download Encore ENHWI-G user manual online.


IEEE g Wireless Broadband Router. ENHWI-G Wireless Router pdf manual download.

Other Drivers