QNAP TS-859U+ TURBO NAS DRIVER DETAILS:
|File Size:||1.2 MB|
|Supported systems:||Windows XP, Windows Vista, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 10, Windows 10 64 bit|
|Price:||Free* (*Free Registration Required)|
QNAP TS-859U+ TURBO NAS DRIVER
Install and Hot-swap Hard Drives
Place the first hard drive in the hard drive cradle and slide it forward to look it into the connector. Place the second hard drive on top of the first hard QNAP TS-859U+ Turbo NAS and secure the screws on the slides of both hard drives.
Connect the SATA cable and power cable to the connectors as shown in the picture. After installing the hard drives, cover the NAS with the casecover and fasten the round head screws. Every file uploaded to the TSU-RP will be made available for all linked devices including computers, QNAP TS-859U+ Turbo NAS and mobile devices. Qsync is especially useful for frequent travelers as it ensures the most up-to-date files are accessible on all linked devices.
If one of the units fails, the other one will take over to supply the power to ensure continuous operation of the NAS. Turn off the NAS. Disconnect the power adaptor, network cable sand any other connectors or cables from QNAP TS-859U+ Turbo NAS NAS. Before installing the memory module, put on an antistatic wrist strap to prevent electrostatic discharge. The crocodile clip should be connected to the ground.
TSU-RP - Features - QNAP (US)
Loosen the three screws on the rear of the NAS. Remove the case cover of the NAS gently. Lift up the Mylar sheet. Locate the memory slot.
Make sure the slot is empty. Grasp the edge of the memory module.
Align the notch on the gold edge of the module with the notch in the memory slot. Slide the memory module to the slot at a degree angle approximately.
|Acer Aspire 5542||Call Today! 800.886.5369|
|Asus U33JC VGA||Product Details|
|ASUS K45DR||Added to Cart|
Gently press the memory module into the slot until it is seated fully. Rotate the memory module towards the motherboard until the securing clips clicks into place. Close the case cover and fasten the screws.
Connect the power adaptor and cables back to the NAS. To check that the memory module is recognized by the NAS, power up the NAS and login the web interface as an administrator. Loosen the six screws on the top of the QNAP TS-859U+ Turbo NAS. Loosen the two screws on the rear of the NAS.
Press the memory module down while holding the clips open. Make sure the memory module sits in properly with the clips in place.
Close the NAS cover and fasten the screws. The total memory will be shown in System Information of QNAP TS-859U+ Turbo NAS administration page. Loosen the 2 screws on the rear of the NAS as shown in the illustration. Hold the notch at the edge of the top cover. Remove the top cover in both hands.
QNAP TSU-RP Turbo NAS Hard Drive Enclosure TSU-RP+-US
Release the ejector clips gently by pulling them out of the sides of the RAM slot. QNap's latest 8-bay NAS appliance is designed to fit in your rack cabinet and has a host of useful storage features.
In this review we see how. On review we have the top dog TS Pro Turbo NAS which supports eight hot-swap SATA drives in a compact desktop chassis. Pricewise, it's RAID: Software managed.